search..
No manual entry for -- in section 8
RED(8)				     Linux				 RED(8)

NAME
       red - Random Early Detection

SYNOPSIS
       tc  qdisc  ... red limit bytes [ min bytes ] [ max bytes ] avpkt bytes [
       burst packets ] [ ecn ] [ harddrop ] [ nodrop ] [  bandwidth  rate  ]  [
       probability  chance  ]  [ adaptive ] [ qevent early_drop block index ] [
       qevent mark block index ]

DESCRIPTION
       Random Early Detection is a classless qdisc which manages its queue size
       smartly. Regular queues simply drop packets from the tail when they  are
       full,  which  may  not  be the optimal behaviour. RED also performs tail
       drop, but does so in a more gradual way.

       Once the queue hits a certain average length, packets  enqueued	have  a
       configurable  chance  of	 being	marked	(which	may mean dropped). This
       chance increases linearly up to a point called  the  max	 average  queue
       length, although the queue might get bigger.

       This  has  a  host  of  benefits	 over  simple taildrop, while not being
       processor intensive. It prevents synchronous retransmits after  a  burst
       in traffic, which cause further retransmits, etc.

       The  goal is to have a small queue size, which is good for interactivity
       while not disturbing TCP/IP traffic with too many sudden drops  after  a
       burst of traffic.

       Depending  on  if  ECN  is  configured, marking either means dropping or
       purely marking a packet as overlimit.

ALGORITHM
       The average queue size is used for determining the marking  probability.
       This  is	 calculated using an Exponential Weighted Moving Average, which
       can be more or less sensitive to bursts.

       When the average queue size is below min bytes, no packet will  ever  be
       marked. When it exceeds min, the probability of doing so climbs linearly
       up  to probability, until the average queue size hits max bytes. Because
       probability is normally not set to 100%, the queue size	might  conceiv-
       ably  rise  above max bytes, so the limit parameter is provided to set a
       hard maximum for the size of the queue.

PARAMETERS
       min    Average queue size at which marking becomes  a  possibility.  De-
	      faults to max /3

       max    At  this	average queue size, the marking probability is maximal.
	      Should be at least twice min to prevent synchronous  retransmits,
	      higher for low min.  Default to limit /4

       probability
	      Maximum  probability  for	 marking, specified as a floating point
	      number from 0.0 to 1.0. Suggested values are 0.01 or 0.02	 (1  or
	      2%, respectively). Default : 0.02

       limit  Hard limit on the real (not average) queue size in bytes. Further
	      packets  are  dropped. Should be set higher than max+burst. It is
	      advised to set this a few times higher than max.

       burst  Used for determining how fast the average queue  size  is	 influ-
	      enced  by the real queue size. Larger values make the calculation
	      more sluggish, allowing longer bursts of traffic	before	marking
	      starts.  Real  life  experiments support the following guideline:
	      (min+min+max)/(3*avpkt).

       avpkt  Specified in bytes. Used with burst to determine	the  time  con-
	      stant for average queue size calculations. 1000 is a good value.

       bandwidth
	      This  rate  is  used for calculating the average queue size after
	      some idle time. Should be set to the bandwidth of your interface.
	      Does not mean that RED will shape for you!  Optional.  Default  :
	      10Mbit

       ecn    As  mentioned  before,  RED can either 'mark' or 'drop'. Explicit
	      Congestion Notification allows RED to notify  remote  hosts  that
	      their rate exceeds the amount of bandwidth available. Non-ECN ca-
	      pable  hosts  can	 only be notified by dropping a packet. If this
	      parameter is specified, packets which indicate that  their  hosts
	      honor  ECN  will only be marked and not dropped, unless the queue
	      size hits limit bytes. Recommended.

       harddrop
	      If average flow queue size is above  max	bytes,	this  parameter
	      forces a drop instead of ecn marking.

       nodrop With  this  parameter,  traffic that should be marked, but is not
	      ECN-capable, is enqueued. Without	 the  parameter	 it  is	 early-
	      dropped.

       adaptive
	      (Added  in  linux-3.3)  Sets RED in adaptive mode as described in
	      http://icir.org/floyd/papers/adaptiveRed.pdf
	      Goal of Adaptive RED is to make 'probability' dynamic value between 1% and 50% to reach the target average queue :
	      (max - min) / 2

QEVENTS
       See tc (8) for some general notes about qevents. The RED qdisc  supports
       the following qevents:

       early_drop
	      The  associated block is executed when packets are early-dropped.
	      This includes non-ECT packets in ECN mode.

       mark   The associated block is executed when packets are marked	in  ECN
	      mode.

EXAMPLE
       # tc qdisc add dev eth0 parent 1:1 handle 10: red
	limit 400000 min 30000 max 90000 avpkt 1000
	burst 55 ecn adaptive bandwidth 10Mbit

SEE ALSO
       tc(8), tc-choke(8)

SOURCES
       o      Floyd,  S., and Jacobson, V., Random Early Detection gateways for
	      Congestion       Avoidance.	 http://www.aciri.org/floyd/pa-
	      pers/red/red.html

       o      Some changes to the algorithm by Alexey N. Kuznetsov.

       o      Adaptive RED  : http://icir.org/floyd/papers/adaptiveRed.pdf

AUTHORS
       Alexey	N.   Kuznetsov,	  <kuznet@ms2.inr.ac.ru>,    Alexey   Makarenko
       <makar@phoenix.kharkov.ua>, J Hadi Salim <hadi@nortelnetworks.com>, Eric
       Dumazet <eric.dumazet@gmail.com>.  This manpage maintained by  bert  hu-
       bert <ahu@ds9a.nl>

iproute2			13 December 2001			 RED(8)