search..
No manual entry for -- in section 8
troff:<standard input>:125: warning [p 2, 2.5i]: cannot break line
CRYPTSETUP-ERASE(8)	      Maintenance Commands	    CRYPTSETUP-ERASE(8)

NAME
       cryptsetup-erase, cryptsetup-luksErase - erase all keyslots

SYNOPSIS
       cryptsetup  erase [<options>] <device>
       cryptsetup luksErase [<options>] <device>

DESCRIPTION
       Erase all keyslots and make the LUKS container permanently inaccessible.
       Unless the device is configured with HW OPAL support you do not need to
       provide any password for this operation.

       WARNING: This operation is irreversible.

       WARNING: with --hw-opal-factory-reset ALL data is lost on the device,
       regardless of the partition it is ran on, if any, and regardless of any
       LUKS2 header backup, and does not require a valid LUKS2 header to be
       present on the device to run.

       <options> can be [--header, --disable-locks, --hw-opal-factory-reset,
       --key-file].

OPTIONS
       --batch-mode, -q
	   Suppresses all confirmation questions. Use with care!

	   If the --verify-passphrase option is not specified, this option also
	   switches off the passphrase verification.

       --debug or --debug-json
	   Run in debug mode with full diagnostic logs. Debug output lines are
	   always prefixed by #.

	   If --debug-json is used, additional LUKS2 JSON data structures are
	   printed.

       --disable-locks
	   Disable lock protection for metadata on disk. This option is valid
	   only for LUKS2 and ignored for other formats.

	   WARNING: Do not use this option unless you run cryptsetup in a
	   restricted environment where locking is impossible to perform (where
	   /run directory cannot be used).

       --header <device or file storing the LUKS header>
	   Use to specify detached LUKS2 header when erasing HW OPAL enabled
	   data device.

       --help, -?
	   Show help text and default parameters.

       --hw-opal-factory-reset
	   Erase ALL data on the OPAL self-encrypted device, regardless of the
	   partition it is ran on, if any, and does not require a valid LUKS2
	   header to be present on the device to run. After providing correct
	   PSID via interactive prompt or via --key-file parameter the device
	   is erased. PSID is usually printed on the OPAL device label (either
	   directly or as a QR code).

       --key-file, -d name (LUKS2 with HW OPAL only)
	   Read the Admin PIN or PSID (with --hw-opal-factory-reset) from file
	   depending on options used.

	   If the name given is "-", then the secret will be read from stdin.
	   In this case, reading will not stop at newline characters.

       --usage
	   Show short option help.

       --version, -V
	   Show the program version.

REPORTING BUGS
       Report bugs at cryptsetup mailing list <cryptsetup@lists.linux.dev> or
       in Issues project section
       <https://gitlab.com/cryptsetup/cryptsetup/-/issues/new>.

       Please attach output of the failed command with --debug option added.

SEE ALSO
       Cryptsetup FAQ
       <https://gitlab.com/cryptsetup/cryptsetup/wikis/FrequentlyAskedQuestions>

       cryptsetup(8), integritysetup(8) and veritysetup(8)

CRYPTSETUP
       Part of cryptsetup project <https://gitlab.com/cryptsetup/cryptsetup/>.

cryptsetup 2.7.5		   2025-05-04		    CRYPTSETUP-ERASE(8)